Attack ChainAIDerived
Hypothetical attack flow derived from CVE metadata – not a confirmed exploit chain
-
AccessGain adjacent access to management network
-
DeliverySend resource-exhausting requests to HMC/BMC
-
ExploitTrigger unbounded computation (CWE-770)
-
ExecutionExhaust firmware resources
-
ImpactDenial of service on management plane
Vulnerability Assessment
| Weakness |
CWE
OWASP Top 10:2025
A06:2025 - Insecure Design
ASVS 5.0
V2 - Validation and Business Logic Resource allocation limits
MITRE ATT&CK
1 technique across 1 tactic: Impact The technique list with ATT&CK links and the kill-chain view is part of the Basic plan and up. |
| Exploitation Conditions | Exploitation requires the attacker to be on an adjacent network reaching the affected component - the IBM Power Hardware Management Console (HMC) or the OpenBMC-based baseboard management controller management interface - consistent with AV:A rather than Internet-wide reach. No authentication is required (PR:N) and no user interaction is needed (UI:N), and attack complexity is low (AC:L), so no special configuration is stated as a precondition in the sources. The primary limiting factor is network adjacency: systems whose HMC/BMC management plane is isolated on a dedicated, access-controlled management VLAN are not reachable by untrusted parties, which is the main realistic constraint on exploitation. Impact is limited to availability (denial of service); there is no confidentiality or integrity impact. The specific feature or protocol path that triggers the excessive resource consumption is not described in the available sources. |
| Impact | This is a moderate-severity availability-only issue (CVSS 6.5, CVSS:3.1/AV:A/AC:L/PR:N/UI:N/S:U/C:N/I:N/A:H) stemming from CWE-770, improper restriction of excessive computational resources. The signals are internally consistent and point to a bounded, non-urgent priority rather than a top-tier emergency: the attack vector is Adjacent (AV:A), meaning the attacker must be on the same logically-adjacent network - typically the service/management network reaching the HMC or OpenBMC BMC - not the open Internet, which substantially narrows exposure. Complexity is low and no privileges or user interaction are required (AC:L/PR:N/UI:N), so an unauthenticated adjacent attacker can trigger it, but impact is confined to availability (C:N/I:N/A:H) with no confidentiality or integrity loss and no scope change. The vuln.today decision label is 'this_month', aligning with a plan-and-patch cadence rather than act_now/emergency. No EPSS score, no CISA KEV listing, and no POC/exploit reference were supplied, so there is no evidence of active exploitation or available weaponization. Note the conflict worth flagging: this CVE was reported by IBM itself (vendor self-disclosure) and the description attaches very specific firmware/OP build ranges, which raises confidence in the affected-versions data, but the lack of EPSS/KEV/POC means real-world exploitation likelihood is unquantified from the input. The mechanism of the resource exhaustion is not described in the available sources. Overall: a legitimate but contained DoS requiring management-network adjacency - remediate on a normal patch cycle, prioritizing systems whose HMC/BMC management plane is reachable by untrusted parties. |
| Exploit ScenarioDerived | An attacker with access to the management/service network segment reaching an affected IBM HMC or OpenBMC-based baseboard management controller sends requests that cause unbounded consumption of computational resources, exhausting the device and producing a denial of service against management functions. No authentication or user interaction is needed (PR:N/UI:N) and complexity is low, but the attacker must first be adjacent on that network (AV:A). No public exploit code or PoC reference was identified at time of analysis, and the specific trigger is not described in the available sources. |
Get an e-mail when this CVE is exploited, patched or re-scored. Free account.
Alert meAnalysisAIv1 – Nov 08, 2026
Denial of service in IBM Power Systems firmware (FW1060.00 through FW1060.81, OP940.00 through OP940.A2, OP940.00 through OP940.82 and OP910.00 through OP910.95) and in the Power Hardware Management Console and OpenBMC management interfaces, rated CVSS 6.5. Adjacent-network attackers without credentials (AV:A/AC:L/PR:N/UI:N) can drive improper restriction of excessive computational resources (CWE-770) until the management component is exhausted and stops responding; confidentiality and integrity are unaffected. No public exploit was identified at time of analysis, and a vendor fix is available per the IBM advisory.
RemediationAI
IBM has released a fix; obtain the corrected firmware and HMC levels from the vendor advisory at https://www.ibm.com/support/pages/node/7294277 and apply the update for each affected branch (FW1060, OP940 and OP910), since the available data does not state a single exact fix version. Where updating must be staged, the practical compensating control matches the assessed exploitation prerequisite: keep HMC and OpenBMC management interfaces off untrusted or user-facing networks and reachable only from a dedicated, access-controlled management VLAN or tightly scoped management jump hosts, accepting that administrators then need routed access through that enclave to manage Power systems. Because no authentication is required for the attack, credential hardening is not a substitute for network restriction, and because the trigger path is not publicly described, rate-limiting or filtering cannot be targeted at a specific protocol field.
Affected VersionsENISA
Affects your stack
Find out whether the stacks and servers you run are on an affected version.
Checking this CVE against your own stacks and servers is part of the Basic plan and up.
Technical ContextAI · show details
The flaw is a CWE-770 uncontrolled-resource-consumption condition in the firmware and management software that fronts IBM Power servers. Two product families are implicated by the published CPE data: IBM OpenBMC (the baseboard management controller firmware stack) and the IBM Power Hardware Management Console (HMC), the appliance used to configure and manage Power hardware. In both cases the exposure sits on the management plane rather than the data plane: an attacker with layer-2/3 adjacency to the BMC or HMC management interface can consume computational resources without authenticating and without user interaction. The evaluated vector (AV:A/AC:L/PR:N/UI:N/S:U/C:N/I:N/A:H) confirms adjacency as the sole reachability constraint and availability as the only impacted property; the specific protocol or feature path that triggers the resource exhaustion is not described in the available sources.
Know when Power Hardware Management Console gets its next vulnerability
- Watch products and get an email when something new is published
- Check this CVE against your own stack and servers
- Exploit and PoC references, threat intelligence from 22 sources
No credit card · 7-day full trial
Severity by source
AV:A/AC:L/PR:N/UI:N/S:U/C:N/I:N/A:H
Management interfaces (HMC/BMC) are reached over an adjacent service network so AV:A; no auth or interaction needed (PR:N/UI:N), and CWE-770 resource exhaustion yields availability-only impact (A:H).
Primary rating from Vendor (ibm).
CVSS VectorNVD
DescriptionNVD
IBM Power Systems Firmware FW1060.00 through FW1060.81, OP940.00 through OP940.A2, OP910.00 through OP910.95, and OP940.00 through OP940.82 could allow a remote attacker to cause a denial of service due to improper restriction of excessive computational resources.
Threat Intelligence Overview
How this decision was reached
The engine reads each signal below and applies a fixed list of rules from top to bottom. The first rule that matches sets the recommended action – like a statement, every line is shown.
What every action level means
SSVC AssessmentENISA
Priority Score
Attack Technique
Denial of Service attacks render applications or systems unavailable by overwhelming resources or triggering failure conditions.
IBM Reliable Scalable Cluster Technology could allow a local user to escalate their privileges to gain root access. Rate
IBM Power Hardware Management Console V10.3.1050.0 could allow an authenticated user to traverse directories on the syst
Improper validation of input length in IBM Power Systems firmware (FW1060.00 through FW1060.81, OP940.00 through OP940.A
The parse_dos_extended function in partitions/dos.c in the libblkid library in util-linux allows physically proximate at
Cross-site scripting (XSS) vulnerability in the Help link in the login panel in IBM Power Hardware Management Console (H
EUVD-2026-119743
GHSA-6j3w-92vm-4x6x
NVD
CVE.org
VulDB
Exploit-DB